12/27/2023 0 Comments Lg incoming call screenThere was a small "device" in its own recess beside the proximity sensor recess. This was enough to bring the surfaces of the glass screen into the detectable range of the proximity sensor and believe it was a "face or Cheek". This was due to residual disrupted adhesive being too thick. However it was not fully seated in its frame but was raised by about 1mm. In this case, the glass screen (cracked) had been removed and replaced. It was so much simpler.Įxcellent summary, most helpful in resolving similar issue with HTC Titan. If you have a phone that was working properly before but is no longer being cooperative, it is probably a dirt, dust, or obstruction issue.Īnyone remember the days of rotary dial phones.If you have a NEW PHONE, it is probably a calibration issue.this will add pressure on the board to be more tight -) tried it and working as normal. I just added a peace of sponge (W:4mm/H:5mm/L:15mm) (all weather door and window sealant) -that comes self adheasive from one side- and sticked a small peace on the board on the opposite side of the phonejack/secondary mic connectors. "need to open the phone (only two screws -) ). I have since installed the 1308 update and this has sorted out the issue" "I powered off the phone, then covered the proximity sensor (near the front camera and the Nokia logo), and powered it on again in a dark place"."shining a very bright light into the proximity sensor". After that my phone keeps working for a few days" " I reboot my phone in a really dark room."uninstalled Skype, took a photo & video with the front camera and soft-rebooted,"."Try pushing hard on the ear speaker(left next to your front camera) "."try gently pushing your screen 'in' this cured the issue for me for my old 920 what used to click when i pressed the top"."apparently if you put pressure between the att logo and the ear speaker on the top of the phone, the screen comes back on" ( My phone isn't ATT, and it doesn't have a logo, but, hey, I'm trying to be thorough.)."The camera trick didn't do it for me until I took a video using the front facing camera.".Very bright out, so indoors phone thinks that the sensor is blocked all the time." "For me help came with using front camera, probably adjusts the sensitivity for light.Did you remove the packing film? If you are using a cover, does it obscure the sensor at all? If so, remove the cover, cut out the appropriate corner, and replace. Make sure that the sensor isn't obstructed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |